Looking After Rented and Owned Paintball Kit
Simple care that keeps borrowed equipment working through the day and makes your own gear last for years.
Rental kit: you are a temporary custodian
Rental equipment gets a hard life, and the staff who maintain it notice who treats it well. You are not expected to service anything. You are expected not to make it worse. Do not drop the marker in the dirt when you sit down, do not rest it barrel-down in mud, and do not leave the loader open in the rain. If something stops working, hand it to staff rather than poking at it. Opening up a rental marker with a borrowed tool is a reliable way to turn a ten-second fix into a bill.
Keeping paint in good condition
Paintballs are more delicate than they look. The shell is made largely of gelatin, the same family of material used for medicine capsules, and it reacts to its surroundings. Damp makes the shells soft and swollen; cold makes them brittle; heat makes them sag and stick together. Keep paint in its bag, in the shade, off the ground, and closed between refills. Never leave it in a hot car or load paint that has been dropped in the dirt, since grit travels straight into the barrel. Paint that has been rained on is finished.
After a ball breaks inside
Sooner or later a ball will burst in the breech or barrel. Shots go wide and the next few balls often break too. Stop firing. If you are on rental gear, walk it to staff. If it is yours, run a squeegee or swab through the barrel, wipe the breech and the inside of the feed neck, and check the loader for broken shell. Carrying on in the hope that it clears itself only spreads sticky fill deeper into the marker.
End-of-day cleaning for your own gear
- Remove the tank and fire off any remaining gas in a safe direction with the barrel cover fitted.
- Take off the barrel and loader. Swab the barrel until the cloth comes out clean and let it dry.
- Wipe paint from the body with a damp cloth. Avoid hosing an electronic marker.
- Empty the loader, wipe it out and leave the lid open to air.
- Clean the mask as its maker advises, and let the foam dry fully before packing.
Dried paint fill is mildly corrosive to finishes and attracts dirt, so a wipe-down on the day beats a scrub a week later.
Seals and lubrication
Gas is held inside a marker by small rubber rings. An O-ring is a loop of elastic material that sits in a groove and is squeezed to form a seal. They dry out, nick and flatten with use, and a hissing leak usually traces back to one of them. Keep a few spares of the sizes your marker uses. Lubricate only as the manual describes, and only with the lubricant it names. General-purpose household oils and sprays can swell or perish the seals, and the wrong product in the wrong place causes more faults than neglect does.
Tanks deserve particular respect
A gas tank is a pressure vessel. Do not drop it, do not leave it in direct sun or a hot vehicle, and protect the threads and the valve with a cap or cover when it is off the marker. High-pressure cylinders must be re-certified at intervals by a hydrostatic test, in which the cylinder is filled with water and pressurised to confirm it is still sound. The date is stamped or printed on the tank, and fields will refuse to fill one that is out of date. Never attempt to remove or alter the valve or regulator yourself.
Storage between outings
Store everything clean, dry and loosely packed. Take batteries out of electronic markers and loaders if they will sit for weeks. Keep the mask in a soft bag where nothing can press on or scratch the lens. Leave leftover paint somewhere cool and dry indoors, and turn the bag over now and then so the balls do not develop flat spots. Much of the wider world of paintball equipment is optional, but whatever you do own repays ten minutes of care after each day.
Before every outing: check the lens, check the tank date, check that the barrel cover is in the bag. Those three are the ones that can stop your day at the gate.
Written by Fenwick Adair · Last built 2026-11-18